Thursday, October 24, 2013

Re: :buffer command, #, $

...

:buffer # works.

:buffer $ does not, but it may be good to make it work.

Reverse (:#buffer and :$buffer) should not work. VimL syntax is already far too complicated for the purpose it is used. Handling # or $ specially for a :buffer command will make it even more complicated.

Note: everything that goes before the command is range. Range is transformed into line numbers before command is processed. Thus it does not receive information about an exact string that expanded into specific line number.


Thanks for the answers guys.  So the buffer 691 makes sense now, since I was editing a file that was 691 lines at the time I executed:
:$b
 
So out of this:
:b#
- Works as I wanted, go to the alternate.

:b$
E93: More than one match for $ 

So in this case, it would be nice to go to the last buffer, essentially special casing the {bufname} partial match when it is just the $.

David


--
--
You received this message from the "vim_use" maillist.
Do not top-post! Type your reply below the text you are replying to.
For more information, visit http://www.vim.org/maillist.php
 
---
You received this message because you are subscribed to the Google Groups "vim_use" group.
To unsubscribe from this group and stop receiving emails from it, send an email to vim_use+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.

No comments:

Post a Comment