Monday, August 24, 2015

Re: How to easily enable "Lua" in Vim 7.4 (would possibly like to avoid building it from source if possible)

On Monday, August 24, 2015 at 7:43:22 PM UTC-5, Annis Monadjem wrote:
> My Vim 7.4 "Lua" is disabled. I need to enable "Lua" in Vim so that I can setup "neocomplete". Is there a way to enable "Lua" without removing/reinstalling my current Vim installation. If I happen to built source from scratch I'm aware about "http://vim.wikia.com/wiki/Building_Vim", however any further detail hints/specification are greatly appreciated (I'm still a beginner). Thanks in advance

That depends on what you mean by "disabled".

If you have Lua support compiled in (with a '+' by the Lua options in :version output) then you just need to install the correct version of Lua to match what Vim was compiled with, and possible set up some paths.

If you do NOT have Lua support compiled in already, then you must compile your own or get a different installation that already has it.

Try some of these if you're on Windows: http://vim.wikia.com/wiki/Where_to_download_Vim

--
--
You received this message from the "vim_use" maillist.
Do not top-post! Type your reply below the text you are replying to.
For more information, visit http://www.vim.org/maillist.php

---
You received this message because you are subscribed to the Google Groups "vim_use" group.
To unsubscribe from this group and stop receiving emails from it, send an email to vim_use+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

No comments:

Post a Comment