Tuesday, August 25, 2015

Re: How to easily enable "Lua" in Vim 7.4 (would possibly like to avoid building it from source if possible)

On Tuesday, August 25, 2015 at 6:46:13 AM UTC+2, Ben Fritz wrote:
> On Monday, August 24, 2015 at 7:43:22 PM UTC-5, Annis Monadjem wrote:
> > My Vim 7.4 "Lua" is disabled. I need to enable "Lua" in Vim so that I can setup "neocomplete". Is there a way to enable "Lua" without removing/reinstalling my current Vim installation. If I happen to built source from scratch I'm aware about "http://vim.wikia.com/wiki/Building_Vim", however any further detail hints/specification are greatly appreciated (I'm still a beginner). Thanks in advance
>
> That depends on what you mean by "disabled".
>
> If you have Lua support compiled in (with a '+' by the Lua options in :version output) then you just need to install the correct version of Lua to match what Vim was compiled with, and possible set up some paths.
>
> If you do NOT have Lua support compiled in already, then you must compile your own or get a different installation that already has it.
>
> Try some of these if you're on Windows: http://vim.wikia.com/wiki/Where_to_download_Vim

Thanks

--
--
You received this message from the "vim_use" maillist.
Do not top-post! Type your reply below the text you are replying to.
For more information, visit http://www.vim.org/maillist.php

---
You received this message because you are subscribed to the Google Groups "vim_use" group.
To unsubscribe from this group and stop receiving emails from it, send an email to vim_use+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

No comments:

Post a Comment