On Tue, Jul 02, 2019 at 05:07:19PM +0100, Paul wrote:
>I noticed that since around 8.1.1561 (or was it 1651?), showcmd would start showing one-off cursor movements (hjklwbe, etc.) in normal mode, very briefly. It's barely noticeable in gvim, more noticeable when sending the keystrokes over a slow connection (eg., remote SSH) — annoying, then, in fact. Yes, I know it is bad form to hold down those keys, but still, I didn't notice Vim doing that before recently.
Any idea about this? It's still happening as of patch 1746. On a remote, slow connection (for visibility), where file is something that Vim has a syntax definition for (again, for visibility), and large enough to scroll up and down for a few moments:
vim -Nu NONE -c 'set showcmd' -c 'syntax on' file
Hold j or k down long enough that Vim has to scroll the file (not just move the cursor). For me, "j"/"k" flickers in the showcmd area.
--
--
You received this message from the "vim_use" maillist.
Do not top-post! Type your reply below the text you are replying to.
For more information, visit http://www.vim.org/maillist.php
---
You received this message because you are subscribed to the Google Groups "vim_use" group.
To unsubscribe from this group and stop receiving emails from it, send an email to vim_use+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/vim_use/20190725113858.GA18983%40rainslide.net.
No comments:
Post a Comment